Examkin

Soru

Zorluk: OrtaBraking Systems

When performing a two-person manual bleeding procedure at an individual wheel brake assembly, what is the correct chronological sequence of steps to purge air from the hydraulic circuit?

  1. 1Attach a transparent drain hose to the bleeder screw with the open end submerged in a container of clean brake fluid.
  2. 2Instruct an assistant to apply and hold continuous downward pressure on the brake pedal.
  3. 3Open the bleeder screw partially to allow pressurized fluid and trapped air bubbles to escape into the drain hose.
  4. 4Close the bleeder screw securely before instructing the assistant to release the brake pedal.

Cevap

The correct sequence begins with connecting the submerged drain tube, followed by pressurizing and holding the brake pedal, opening the bleeder screw to purge air, and finally tightening the bleeder screw before releasing the pedal.
Purging air from a hydraulic brake circuit requires positive pressure to expel air pockets and immediate sealing to prevent air ingestion. The technician first attaches a submerged hose, commands the assistant to pressurize the line, opens the bleeder valve to vent air and fluid, and tightens the valve before the pedal is released.

Adım Adım Çözüm

1
Connect the drain tube to the bleeder valve and submerge its tip in clean fluid.
Creates a sealed escape route for contaminated fluid and air.
Prevents air from being drawn backwards into the hydraulic circuit during the bleeding process.
2
Have an assistant depress and maintain steady pressure on the brake pedal.
Pressurizes the hydraulic fluid column from the master cylinder to the wheel unit.
Generates positive hydraulic pressure to drive trapped air pockets toward the exit port.
3
Loosen the bleeder screw one-quarter to one-half turn.
Pressurized fluid and air bubbles discharge through the transparent tube.
Expels trapped air out of the hydraulic cylinder or caliper bore.
4
Tighten the bleeder screw firmly before the assistant releases the pedal.
Reseals the hydraulic system under positive pressure.
Releasing the brake pedal creates low-pressure suction in the circuit; sealing the valve first prevents air from being sucked back inside.

Anahtar Kavram

Hydraulic brake bleeding sequence and positive pressure sealing
Tahmini Süre:1m 0s
Bu soruyu puanla

Konular

Braking Systems

Bu konudan daha fazla soru