Examkin

Soru

Zorluk: ZorSoldering Equipment

A technician is preparing to install a heat-sensitive transistor onto a printed circuit board terminal using an electric soldering pencil and rosin-core solder. What is the correct sequential order of steps the technician must follow to complete the solder connection properly without damaging the component or creating a defective joint?

  1. 1Wipe the heated soldering iron tip across a damp sponge and apply a thin layer of fresh solder to tin the tip.
  2. 2Attach a thermal shunt (heat sink clip) onto the transistor lead between the component body and the intended joint area.
  3. 3Place the tinned iron tip firmly against both the component lead and the circuit board pad simultaneously.
  4. 4Feed the rosin-core solder wire directly into the junction point opposite the soldering iron tip until solder flows evenly around the lead and pad.
  5. 5Withdraw the solder wire, remove the soldering iron tip, and leave the joint completely stationary while it solidifies.

Cevap

The proper sequence is: (1) Clean and tin the soldering iron tip on a damp sponge, (2) attach a thermal shunt to the transistor lead, (3) apply the iron tip simultaneously to both the lead and the pad, (4) feed rosin-core solder into the heated junction opposite the iron, and (5) remove the solder, withdraw the iron, and allow the connection to cool undisturbed.
High-reliability electronic soldering follows a strict thermodynamic and metallurgical order: preparing the heat transfer medium (cleaning/tinning), safeguarding delicate active devices with a thermal shunt, heating the target metals to soldering temperature, feeding flux-cored solder directly into the joint to facilitate capillary action, and finally removing the heat source while avoiding physical disturbance during crystallization.

Adım Adım Çözüm

1
Prepare and tin the soldering tip
The tip is free of oxidized residue and coated with a bright, molten solder film.
Tinning creates a liquid solder bridge that dramatically improves heat conductivity into the connection.
2
Position protective thermal tooling
A metallic heat sink clip is fastened between the transistor body and the soldering zone.
Semiconductor junctions can be permanently damaged by excessive heat; the shunt dissipates thermal energy before reaching internal silicone layers.
3
Preheat the connection elements
Both the copper terminal pad and the component lead reach the wetting temperature of solder.
Solder only adheres properly and flows over surfaces that are at or above its liquidus temperature.
4
Introduce solder alloy and flux to the workpiece
Rosin flux cleans surface oxides while molten solder forms a concave wetting fillet around the lead.
Melting solder onto the workpieces rather than directly against the iron tip prevents flux burnout and cold joints.
5
Remove tools and allow undisturbed solidification
The alloy freezes into a shiny, smooth, mechanically sound metallurgical bond.
Moving the joint while the alloy passes through its plastic phase creates a crystallized, high-resistance cold solder joint.

Anahtar Kavram

Procedural stages of electronic soldering, thermal protection, and joint solidification

Alternatif Yöntem

For desoldering rather than soldering, the sequence reverses slightly: clean/tin tip, apply desoldering braid or vacuum pump nozzle to the preheated joint, depress the suction plunger, and verify lead release before component removal.
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Soldering Equipment

Bu konudan daha fazla soru