An automotive technician is replacing a wheel assembly on a passenger vehicle following standard shop safety and torque procedures. What is the correct chronological sequence of steps for mounting and securing the wheel to ensure proper clamping force and prevent brake rotor distortion?
- 1Clean and inspect the wheel studs and hub mounting surface for rust, debris, or thread damage.
- 2Position the wheel onto the hub and thread all lug nuts on by hand until they are snug against the wheel taper.
- 3Lower the vehicle until the tire makes slight contact with the shop floor to prevent the wheel from turning.
- 4Tighten the lug nuts to the manufacturer's specified torque using a calibrated torque wrench in a crisscross or star pattern.
- 5Lower the vehicle completely to the floor and remove the lifting equipment.
Cevap
Clean and inspect the hub and studs, mount the wheel and hand-snug the lug nuts, lower the vehicle to partial ground contact to prevent spinning, tighten all lug nuts in a crisscross pattern with a calibrated torque wrench, and finally lower the vehicle completely to the floor.
Proper wheel installation requires preparing the mating surfaces first to eliminate runout, hand-snugging nuts while raised to ensure proper thread alignment, lowering the tire only enough to hold it stationary, achieving final torque with a calibrated wrench in a crisscross sequence to balance clamping stress, and lastly lowering the vehicle fully to the floor.
Adım Adım Çözüm
Anahtar Kavram
Standard shop procedure for wheel installation, hub preparation, and star-pattern torque sequence to maintain correct clamping load and prevent rotor warping.
Tahmini Süre:1m 30s