Examkin

Soru

Zorluk: OrtaHazardous Materials and Disposal

To comply with environmental protection and hazardous waste disposal standards, used automotive spin-on oil filters must undergo hot-draining before the metal canisters can be recycled. In what sequential order should a technician perform the steps to safely drain and process a used oil filter for disposal?

  1. 1Puncture the dome end or anti-drainback valve of the warm oil filter.
  2. 2Place the punctured filter upside-down over a waste oil collection basin to gravity-drain for at least 12 hours.
  3. 3Compress the drained filter canister using a mechanical filter crusher to extract remaining trapped oil.
  4. 4Place the flattened metal casing into a dedicated scrap metal recycling bin.

Cevap

Puncture the dome end or anti-drainback valve -> Place the punctured filter upside-down over a waste oil collection basin to gravity-drain for at least 12 hours -> Compress the drained filter canister using a mechanical filter crusher -> Place the flattened metal casing into a dedicated scrap metal recycling bin.
The correct sequence begins by puncturing the filter dome or anti-drainback valve while the unit is warm to eliminate internal vacuum locks. Next, the filter is placed upside-down over a waste oil collection basin to gravity-drain for at least 12 hours. After gravity drainage, the filter is placed in a mechanical press to crush the casing and expel residual oil trapped in the media. Finally, the drained and flattened metal casing is deposited into a scrap metal recycling bin as exempt, non-hazardous scrap.

Adım Adım Çözüm

1
Puncture the dome top or anti-drainback valve of the warm filter.
Creates an atmospheric vent and bypasses the one-way rubber flapper valve.
Air must displace the fluid inside the canister to prevent a vacuum lock that holds used oil inside the pleats.
2
Position the inverted filter on a drainage rack over the used oil collection tank for at least 12 hours.
Allows all free-flowing petroleum fluids to drain into the bulk storage tank.
Federal and environmental regulations require a minimum 12-hour hot-drain period for gravity separation of used oil.
3
Place the gravity-drained canister into an approved mechanical filter crusher.
Compresses the steel shell to a fraction of its original size while expelling residual trapped fluid.
Crushing ensures maximum oil reclamation and prepares the filter body for non-hazardous scrap classification.
4
Deposit the flattened canister into a designated scrap metal container.
Diverts clean solid metal waste into scrap recycling channels.
Properly hot-drained and crushed oil filters are exempt from hazardous waste landfill disposal restrictions.

Anahtar Kavram

Standard hot-draining, volume reduction, and non-hazardous scrap recycling procedures for automotive oil filters under hazardous waste management guidelines.
Tahmini Süre:1m 0s
Bu soruyu puanla

Konular

Hazardous Materials and Disposal

Bu konudan daha fazla soru