Examkin

Soru

Zorluk: OrtaWireless LAN Client Connectivity Configuration via WLC GUI

A network administrator is configuring a newly created Wireless LAN (WLAN) on a Cisco Wireless LAN Controller (WLC) using the GUI. The administrator must map client traffic on this WLAN to a specific VLAN interface and ensure the network is active for client association. Which TWO settings are located directly under the General tab of the WLAN configuration page?

  1. Selecting the appropriate dynamic interface or interface group from the Interface/Interface Group drop-down menuCevap
  2. Selecting the Status checkbox to enable the WLAN for client connectionsCevap
  3. C
    Selecting WPA2-Enterprise under the Layer 2 security policy parameters
  4. D
    Configuring the primary RADIUS server IP address and shared secret for client authentication

Cevap

The correct settings located under the General tab are selecting the appropriate dynamic interface from the Interface/Interface Group drop-down menu and selecting the Status checkbox to enable the WLAN.
On a Cisco WLC GUI, the General tab for a WLAN contains fundamental operational settings including Profile Name, SSID, Status (enabled/disabled), and Interface/Interface Group binding. Choosing the appropriate interface maps the WLAN to a specific VLAN, and checking Status activates the WLAN for wireless client association.

Adım Adım Çözüm

1
Identify the parameters configured on the General tab during Cisco WLC WLAN setup.
The General tab contains parameters such as Profile Name, SSID, Status (Enabled/Disabled), Radio Policy, and Interface/Interface Group mapping.
These basic operational settings define the identity, network mapping, and operational state of the WLAN.
2
Evaluate the requirement to map client traffic to a specific VLAN and enable client association.
Mapping client traffic requires selecting the target interface under Interface/Interface Group, and enabling client association requires checking the Status checkbox.
Both of these configuration fields reside directly within the General tab.
3
Distinguish General tab parameters from Security tab parameters.
WPA2 security policies and RADIUS server configurations are located under the Security tab (Layer 2 sub-tab and AAA Servers sub-tab respectively).
Security and authentication mechanisms are isolated in dedicated sub-tabs under the Security main menu.

Anahtar Kavram

Cisco WLC GUI WLAN General Tab Configuration
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Wireless LAN Client Connectivity Configuration via WLC GUI

Bu konudan daha fazla soru