Examkin

Soru

Zorluk: OrtaInspection Fundamentals and Reasons

While performing a comprehensive pre-trip vehicle walk-around inspection, a commercial driver checks several mechanical tolerances and safety systems across the vehicle. Which of the following observed vehicle conditions indicates a critical safety defect that requires correction prior to operating the vehicle on public roadways?

  1. A
    A drive-axle tire exhibiting 3/32-inch remaining tread depth evenly across all major grooves.
  2. A steering wheel that exhibits 2.5 inches of free play at the rim of a 20-inch wheel before the front wheels respond.Cevap
  3. C
    An in-cab emergency safety kit containing three bidirectional reflective triangles and spare fuses, but no liquid burning flares.
  4. D
    A manual brake slack adjuster pushrod that travels 0.5 inch when pulled firmly by hand with the spring brakes released.

Cevap

A steering wheel exhibiting 2.5 inches of free play on a 20-inch wheel indicates a critical safety defect that must be corrected before operating the vehicle.
Steering wheel free play exceeding 10 degrees (approximately 2 inches of play on a 20-inch wheel) creates severe steering lag and instability, representing an immediate critical safety defect under inspection regulations.

Adım Adım Çözüm

1
Evaluate the steering system play tolerance against federal commercial vehicle standards.
Maximum acceptable steering play is 10 degrees, which corresponds to approximately 2 inches on a 20-inch diameter steering wheel.
Excessive play beyond 2 inches impairs driver vehicle control and responsiveness.
2
Compare observed steering play of 2.5 inches against the 2.0-inch threshold.
The observed 2.5 inches exceeds the allowable limit by 0.5 inch.
Any mechanical tolerance exceeding the established safety threshold represents an out-of-service or hazardous condition.
3
Verify compliance of other inspected components.
3/32-inch drive tire tread exceeds the 2/32-inch minimum; emergency equipment satisfies the triangle requirement; 0.5-inch pushrod travel is below the 1-inch limit.
Confirming that all other options reflect compliant conditions identifies the single non-compliant defect.

Anahtar Kavram

Identification of critical mechanical defects and allowable tolerances during safety inspections
Tahmini Süre:1m 15s
Bu soruyu puanla

Konular

Inspection Fundamentals and Reasons

Bu konudan daha fazla soru