Examkin

Soru

Zorluk: ZorSpeed on Curves and Downgrades

A commercial motor vehicle approaches a steep downhill grade that transitions midway into a sharp, unbanked curve before continuing downward. In what chronological sequence should the driver perform these operational steps to maintain vehicle stability, protect against thermal brake fade, and negotiate both the downgrade and curve safely?

  1. 1Shift the transmission into a low gear that provides sufficient engine braking before cresting the hill and starting the descent.
  2. 2Execute snub braking cycles on the upper descent by braking firmly to reduce speed 5 mph5\text{ mph} below the safe speed, then fully releasing the brakes.
  3. 3Apply the service brakes smoothly before entering the curve to drop vehicle speed at or below the posted curve advisory speed.
  4. 4Maintain light engine throttle throughout the curve without applying the service brakes.
  5. 5Resume intermittent snub braking cycles on the remaining downgrade once the vehicle has completely straightened onto the roadway.

Cevap

The proper procedural sequence is: (1) Shift into proper low gear before cresting the hill; (2) Execute snub braking cycles on the upper descent; (3) Brake down to or below advisory speed prior to entering the curve; (4) Maintain light throttle through the curve without braking; (5) Resume snub braking cycles on the remaining downgrade after exiting the curve.
The correct sequence prioritizes mechanical engine retarding before descent begins, manages brake heat via cyclical snub applications on straight sections, eliminates braking forces during curve negotiation to preserve steering traction, and returns to cyclical speed control once straight.

Adım Adım Çözüm

1
Pre-select the appropriate low transmission gear before starting down the hill.
Engine compression braking is engaged to provide primary retarding force without overheating mechanical brakes.
Attempting to downshift after starting down a steep grade risks getting stuck in neutral and causing a runaway vehicle.
2
Control speed on the upper slope using the snub braking technique.
Vehicle speed remains within 5 mph5\text{ mph} of the designated safe speed while allowing cooling intervals.
Continuous light pedal pressure causes rapid heat accumulation and severe brake fade, whereas snub braking allows thermal recovery.
3
Decelerate to the curve advisory speed before reaching the curve's point of curvature.
The vehicle enters the curve at a safe lateral acceleration threshold.
Traction is shared between steering and braking; braking prior to the turn preserves maximum cornering traction.
4
Guide the combination through the curve with slight engine power and no brake application.
Vehicle components remain in tension and lateral stability is maintained.
Braking inside a curve on a downgrade can easily induce a jackknife or trailer rollover due to load shift and traction limits.
5
Re-establish standard snub braking on the straight lower section of the grade.
Descent speed is maintained within the safe envelope until reaching level terrain.
Once lateral cornering forces subside, the friction brakes can again be utilized safely for cyclical speed reduction.

Anahtar Kavram

Integrated speed control combining pre-descent gear selection, snub braking thermal management, and pre-curve deceleration physics.
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Speed on Curves and Downgrades

Bu konudan daha fazla soru