During an en-route walkaround inspection following reports that a commercial tractor-trail… — Commercial Driver's License (CDL) General Knowledge Exam

During an en-route walkaround inspection following reports that a commercial tractor-trailer is pulling unevenly during brake applications, the driver chocks the wheels and systematically examines the foundation brake assemblies across all wheel positions. Which of the following observed conditions represents a critical defect that requires placing the brake assembly out of service before the vehicle is operated?

A
A manual slack adjuster pushrod free play measurement of $3/4\text{ inch}$ when pulled firmly by hand with the parking brakes released
The presence of grease and hub lubricant contamination on the brake shoe friction lining and inner drum surfaceCevap
C
A drum brake friction lining thickness measuring $5/16\text{ inch}$ at the thinnest point of the shoe
D
Zero pushrod movement observed at the brake chamber when pulling the slack adjuster while the spring brakes remain fully applied

Cevap

The presence of grease and hub lubricant contamination on the brake shoe friction lining and inner drum surface

Any grease, oil, or fluid contamination on brake friction linings or the inner braking surface of the drum destroys the coefficient of friction, leading to severe brake fade, vehicle pulling, and immediate out-of-service designation.

Adım Adım Çözüm

Analyze the friction surface condition for structural integrity and contamination.

Grease or oil contamination on brake friction material compromises friction coefficients and causes uneven braking forces.

Commercial vehicle safety regulations prohibit any oil, grease, or lubricant on the friction face of brake linings and drums.

Evaluate the manual slack adjuster pushrod free play against regulatory inspection limits.

A travel measurement of

3/4\text{ inch}

is below the maximum allowable threshold of

1\text{ inch}

for manual free play.

Manual slack adjusters are properly adjusted if pushrod travel does not exceed approximately

1\text{ inch}

when pulled hard by hand with parking brakes released.

Evaluate the brake shoe lining thickness against wear limits.

A thickness of

5/16\text{ inch}

(

0.3125\text{ inch}

) is greater than the

1/4\text{ inch}

(

0.25\text{ inch}

) minimum wear limit.

Commercial drum brake linings are considered worn out and defective only when worn thinner than

1/4\text{ inch}

Assess the procedural validity of checking pushrod travel with spring brakes applied.

Zero travel with set spring brakes reflects an improper testing procedure rather than a verified mechanical status.

Pushrod travel cannot be measured while spring brakes apply mechanical force; wheels must be chocked and parking brakes released to check free play.

Anahtar Kavram

Foundation brake component inspection standards, wear limits, and contamination defects

Tahmini Süre:1m 30s

Soru

Cevap

Adım Adım Çözüm

Anahtar Kavram

Sık Yapılan Hatalar

Konular

Bu konudan daha fazla soru