Examkin

Soru

Zorluk: ZorEn-Route and Post-Trip Inspections

An interstate motor carrier safety manager is establishing standard operating procedures for drivers operating combination tractor-trailers on long-haul routes. The protocol must properly integrate both en-route monitoring intervals and post-trip Driver Vehicle Inspection Report (DVIR) corrective action procedures. Which of the following procedures fully satisfies commercial vehicle inspection and reporting requirements?

  1. A
    Re-inspecting cargo securement and critical mechanical components every 5 hours or 300 miles after an initial 100-mile check, and omitting DVIR notation for front steer tires with 2/32-inch tread depth since 2/32 inch meets standard drive axle requirements.
  2. B
    Performing en-route checks every 3 hours or 150 miles, and allowing drivers to manually adjust automatic slack adjusters during post-trip inspections to clear brake pushrod travel warnings without recording the condition on the DVIR.
  3. Examining cargo securement within the first 50 miles and every 3 hours or 150 miles thereafter, followed by completing a written post-trip DVIR at the end of the shift with certified mechanic signatures required for any noted safety defects before the vehicle is dispatched again.Cevap
  4. D
    Checking en-route vehicle components only when taking mandatory rest breaks, while classifying steering wheel free play of up to 3 inches on a 20-inch wheel as acceptable operating tolerance that does not require DVIR documentation.

Cevap

The procedure requiring cargo and component checks within the first 50 miles and every 3 hours or 150 miles, along with completing a written post-trip DVIR where noted safety defects require certified technician repair signatures prior to the next dispatch.
The correct procedure strictly adheres to the standard en-route inspection schedule (first 50 miles, and every 3 hours or 150 miles thereafter) and enforces the requirement that safety defects noted on the post-trip DVIR receive certified maintenance sign-offs before subsequent operation.

Adım Adım Çözüm

1
Determine the mandatory en-route inspection timeline for commercial vehicles.
Regulations dictate an initial inspection within the first 50 miles of travel and recurring checks every 3 hours or 150 miles (whichever comes first), in addition to every duty status change or break.
En-route checks ensure cargo remains properly secured and vital mechanical systems like tires, brakes, and coupling devices have not degraded under operating heat and stress.
2
Examine the post-trip Driver Vehicle Inspection Report (DVIR) corrective action regulations.
Drivers must prepare a written DVIR at the conclusion of each daily driving shift; if safety-related defects are found, a motor carrier or mechanic must certify repairs or certify that repairs are unnecessary before the vehicle can be operated again.
Documented certification guarantees that out-of-service defects are resolved prior to the next driver taking control of the vehicle.
3
Evaluate the mechanical tolerance distractors against commercial safety standards.
Steer axle tires require at least 4/32 inch4/32\text{ inch} of tread depth, steering wheel free play cannot exceed 2 inches on a 20-inch wheel, and automatic slack adjusters must not be manually reset to hide pushrod stroke defects.
Identifying these non-compliant tolerances confirms that the option integrating the correct intervals with complete DVIR sign-off rules is the only valid protocol.

Anahtar Kavram

En-route inspection intervals, mechanical defect tolerances, and post-trip DVIR corrective action workflow
Tahmini Süre:2m 0s
Bu soruyu puanla

Konular

En-Route and Post-Trip Inspections

Bu konudan daha fazla soru