Examkin

Soru

Zorluk: ZorWinter Driving

A commercial motor vehicle driver must install conventional tire chains on the drive wheels before entering a mountain pass under severe winter storm conditions. What is the correct chronological sequence for safely mounting, securing, and testing the tire chains?

  1. 1Pull entirely off the active roadway into a designated chain-up area on level ground, apply the parking brakes, and activate four-way emergency flashers.
  2. 2Unfold and lay the tire chains flat on the ground to remove twists, ensuring the open hooks of the cross chains face away from the tire sidewall.
  3. 3Drape the chains evenly over the drive tires or roll the wheels onto them so the cross chains are centered across the tire tread surface.
  4. 4Fasten the inner side-chain connector first, connect the outer side-chain fastener, and take up remaining slack using chain cams or rubber tensioners.
  5. 5Drive the vehicle forward 50 to 100 feet at low speed, bring it to a complete stop in the staging zone, and retighten any loose chain links.

Cevap

The correct sequence begins with parking and securing the vehicle in a designated chain-up area, untangling and laying out chains with hook ends facing away from sidewalls, draping and centering the chains over the drive tires, fastening the inner connector before the outer connector with tensioners, and driving forward 50 to 100 feet to perform a mandatory stop and retightening.
The correct operational order ensures maximum driver safety, prevents tire casing damage, and guarantees proper chain retention. Drivers must first secure the vehicle in a designated pull-off zone, inspect and lay out chains with cross-chain hook ends facing outward away from rubber, center the chains over the drive tires, fasten the inside connector before the outside connector, and finally drive forward 50 to 100 feet to stop and retighten any slack that settles out during rotation.

Adım Adım Çözüm

1
Secure vehicle in safe designated staging area with parking brakes and flashers.
Establishes a safe environment away from moving traffic and prevents unintended vehicle movement.
Safety protocol dictates establishing perimeter safety before working adjacent to or underneath commercial vehicle wheels.
2
Lay out chains flat and orient hooks outward.
Eliminates chain binding and prevents sharp cross-chain hooks from gouging the tire casing.
Hooks facing inward can pinch, abrade, or puncture tire sidewalls under heavy axle loads.
3
Drape chains squarely over the top of the drive tires.
Aligns cross links symmetrically across the contact patch.
Even alignment is required so both side chains reach their respective connection points without binding.
4
Hook inner side chain first, then outer side chain, and engage tensioners.
Locks the chain framework securely around the tire circumference.
Connecting the inside first ensures proper clearance around suspension components and brake lines before tensioning the exterior face.
5
Drive forward 50 to 100 feet and perform a final tension check.
Draws out centrifugal slack and seats the chain links securely against the tread lugs.
Initial movement allows links to settle into the tread voids; failing to retighten can lead to thrown chains or damage to brake and air lines.

Anahtar Kavram

Standard procedural safety and mechanical sequence for commercial vehicle tire chain installation and retensioning in winter driving environments.
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Winter Driving

Bu konudan daha fazla soru