Examkin

Soru

Zorluk: OrtaBrake System Components Inspection

Commercial vehicle safety inspection standards permit the installation of different brake chamber sizes or unequal slack adjuster arm lengths across opposite ends of the same axle, provided pushrod travel on both sides remains within legal operating limits.

Cevap: Cevap

Cevap

The statement is False.
The statement is false because safety standards require brake chambers and slack adjusters across the same axle to be matched in size, type, and effective arm length to ensure equalized braking torque and prevent directional pull during application.

Adım Adım Çözüm

1
Analyze the brake components and mechanical configuration described in the statement.
The statement proposes that differing brake chamber sizes or unequal slack adjuster arm lengths on the same axle are acceptable if pushrod travel is within legal limits.
Identifying the components and axle layout establishes whether mechanical symmetry across the axle is being maintained.
2
Apply commercial motor vehicle safety standards regarding foundation brake hardware matching across an axle.
Braking force is directly determined by the brake chamber diaphragm area multiplied by air pressure and multiplied by the slack adjuster effective arm length. Mismatched components generate unequal braking forces between the left and right wheels.
Uniform braking force across each axle is required to prevent severe steering pull, wheel lockup, jackknifing, or out-of-service conditions.
3
Determine the validity of the statement.
Because matched brake chambers and identical slack adjuster arm lengths are mandatory across any given axle regardless of stroke measurement, the statement is false.
Stroke compliance alone does not offset the severe hazard created by asymmetric braking torque.

Anahtar Kavram

Brake Chamber and Slack Adjuster Axle Symmetry
Tahmini Süre:1m 0s
Bu soruyu puanla

Konular

Brake System Components Inspection

Bu konudan daha fazla soru