Examkin

Soru

Zorluk: OrtaBrake System Components Inspection

An operator is examining the air lines, brake chambers, and mounting hardware on a drive axle assembly. Which of the following conditions represents a safety defect that requires immediate correction before operating the vehicle?

  1. A
    A brake chamber pushrod forming an approximate 90-degree angle with the slack adjuster arm when service brakes are fully applied
  2. B
    Light surface corrosion and dry road dust across the exterior of the brake chamber clamping band
  3. An air supply hose showing visible internal fabric braid reinforcement due to rubbing against a suspension bracketCevap
  4. D
    A rubber S-cam shaft grease seal exhibiting minor cosmetic weathering without grease leakage

Cevap

An air supply hose showing visible internal fabric braid reinforcement due to rubbing against a suspension bracket
Commercial vehicle safety inspection regulations prohibit operating with air brake lines or hoses that are cracked, flattened, spliced, or chafed through the protective outer rubber layer to expose the fabric or wire reinforcement. Visible reinforcement plies indicate severe wall degradation, presenting an immediate hazard of air loss or catastrophic hose rupture during braking.

Adım Adım Çözüm

1
Examine the physical condition of the air supply lines and foundation brake assemblies against safety inspection standards.
Identify that flexible air hoses must not be chafed, abraded, or worn down to the reinforcing ply.
Air brake lines contain high-pressure air; exposure of the reinforcement material indicates structural loss of wall thickness and imminent risk of pressure loss.
2
Differentiate between critical component defects and normal cosmetic wear or proper operating geometry.
Confirm that a 90-degree applied pushrod angle is the intended operational geometry, while minor clamp rust and dry seal weathering are benign.
Accurate identification prevents driving with compromised pressure components while avoiding unnecessary out-of-service delays for normal operating conditions.

Anahtar Kavram

Foundation brake component inspection standards for air lines and brake chambers
Tahmini Süre:1m 0s
Bu soruyu puanla

Konular

Brake System Components Inspection

Bu konudan daha fazla soru