Examkin

Soru

Zorluk: KolayWindows Client Networking Configuration

A technician needs to refresh the IPv4 configuration on a Windows client workstation using the command line. Place the steps in the correct order from first to last to properly release, renew, and verify the network configuration.

  1. 1Open the Windows Command Prompt.
  2. 2Run the command `ipconfig /release`.
  3. 3Run the command `ipconfig /renew`.
  4. 4Run the command `ipconfig /all`.

Cevap

The correct order is: Open the Windows Command Prompt, run `ipconfig /release` to drop the current IP lease, run `ipconfig /renew` to request a new lease from the DHCP server, and run `ipconfig /all` to verify the assigned configuration.
To refresh a DHCP lease on Windows, a technician must first open the command-line interface, release the existing lease using `ipconfig /release`, request a new lease using `ipconfig /renew`, and finally inspect the resulting setup with `ipconfig /all`.

Adım Adım Çözüm

1
Open Command Prompt
Command-line environment is available for administrative networking tasks.
CLI commands must be executed within an active shell environment.
2
Execute `ipconfig /release`
Sends a DHCPRELEASE message to the DHCP server and clears local IPv4 configuration.
The existing IP address must be released before requesting a fresh lease.
3
Execute `ipconfig /renew`
Sends a DHCPREQUEST message to obtain a new IP address, subnet mask, default gateway, and DNS configuration.
Obtaining a new configuration establishes functional network parameters.
4
Execute `ipconfig /all`
Displays detailed IP settings to confirm successful lease assignment.
Verification confirms that proper IP parameters were received and applied.

Anahtar Kavram

Windows Command-Line DHCP Renewal Procedure
Bu soruyu puanla

Konular

Windows Client Networking Configuration

Bu konudan daha fazla soru