Examkin

Soru

Zorluk: OrtaPrinter and Multifunction Device Issues

An IT technician is servicing an enterprise laser printer that has reached its scheduled maintenance interval and is displaying a maintenance prompt. In what order should the technician execute the steps required to safely replace the maintenance kit components and reset the device?

  1. 1Power off the printer, disconnect the main power cable, and allow the fuser assembly to cool down.
  2. 2Remove and replace the worn fuser assembly, transfer roller, and paper pickup/feed rollers with new components.
  3. 3Reconnect the main power cable and turn on the printer to complete its self-test.
  4. 4Access the printer administration menu and reset the maintenance page counter.

Cevap

The technician must first power off the printer and let the fuser cool, replace the fuser, transfer roller, and pickup rollers, reconnect power and turn the printer back on, and finally reset the printer maintenance page counter in the management menu.
The correct sequence prioritizes technician safety by disconnecting power and cooling the fuser first. Hardware parts (fuser, transfer roller, pickup rollers) are replaced next. Restoring power allows the printer to complete its self-test, after which the administrative maintenance counter can be reset to clear the prompt and begin a new maintenance tracking cycle.

Adım Adım Çözüm

1
Power off and disconnect the printer, allowing the fuser to cool down.
Electrical safety is ensured and burn risks from the fuser (which operates near 400°F/200°C) are eliminated.
CompTIA safety guidelines dictate removing power sources and mitigating thermal hazards prior to opening internal assemblies.
2
Swap out the old maintenance kit parts (fuser assembly, transfer roller, pickup/feed rollers) for new ones.
Worn mechanical components are replaced with fresh hardware.
Physical component replacement must occur while the device is unpowered and cool.
3
Reconnect power and turn the printer back on.
The printer conducts its initial POST (Power-On Self-Test) and enters a ready state.
The system must be online to access administrative menus and verify mechanical operation.
4
Navigate to the control panel settings menu to reset the maintenance counter.
The warning message clears and the internal cycle counter resets to zero.
The printer cannot automatically detect mechanical part replacement; manual counter reset is required to track the next maintenance cycle accurately.

Anahtar Kavram

Laser Printer Maintenance Kit Replacement Procedure and Safety
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Printer and Multifunction Device Issues

Bu konudan daha fazla soru