Examkin

Soru

Zorluk: OrtaTroubleshooting Physical Cabling and Connectors

A network technician is troubleshooting an IP surveillance camera connected via an 80-meter Category 6 Ethernet drop. Although basic wiremap testing confirms all eight conductors have pin-to-pin continuity with no opens or shorts, the camera regularly experiences frame drops and fails to negotiate a 1000Base-T link, falling back to 100Mbps. The technician suspects high signal degradation and Near-End Crosstalk (NEXT) caused by excessive untwisting of wire pairs near the patch panel punch-down termination. Which of the following tools should the technician use to perform a full frequency performance analysis and verify whether the cable run complies with Category 6 standards?

  1. Cable certifierCevap
  2. B
    Time-Domain Reflectometer (TDR)
  3. C
    Tone generator and probe kit
  4. D
    Digital multimeter

Cevap

The cable certifier is the appropriate tool because it measures complex signal performance metrics such as Near-End Crosstalk (NEXT) and attenuation across category standards.
The option recommending a cable certifier is correct because certifiers perform full-spectrum electrical testing across the frequency range required by TIA/EIA standards (such as Cat 6), measuring parameters like Near-End Crosstalk (NEXT), return loss, and attenuation to verify 1000Base-T capability.

Adım Adım Çözüm

1
Analyze the reported symptoms and physical environment.
Basic DC continuity and pin mapping pass, eliminating opens, shorts, and wiremap errors as the cause of failure. However, Gigabit link negotiation fails and high-speed traffic drops frames over an 80-meter Category 6 run.
When pin continuity is intact but high-speed link negotiation fails, high-frequency transmission parameters like crosstalk or attenuation are failing.
2
Identify the specific performance parameter being tested.
The technician suspects Near-End Crosstalk (NEXT) due to un-twisted copper conductors near the patch panel.
NEXT occurs when signals on one wire pair bleed into an adjacent pair due to degraded pair twisting or poor termination practice.
3
Select the diagnostic instrument capable of assessing high-frequency cable standards.
Choose a cable certifier.
Only a cable certifier tests electrical performance against TIA/EIA standard specifications (e.g., Cat 6 up to 250 MHz) to qualify cabling for specific Ethernet standards like 1000Base-T.

Anahtar Kavram

Selecting Cabling Troubleshooting Tools for High-Frequency Certification
Tahmini Süre:1m 15s
Bu soruyu puanla

Konular

Troubleshooting Physical Cabling and Connectors

Bu konudan daha fazla soru