Examkin

Soru

Zorluk: Çok zorPharmacological and Parenteral Therapies

A nurse is preparing to administer a prescribed intravenous (IV) piggyback dose of a reconstituted antibiotic. The client has a continuous primary IV infusion of 0.9%0.9\% sodium chloride running via an electronic infusion pump. Arrange the following steps in the correct chronological order to safely prepare and initiate the secondary IV piggyback infusion. All steps must be used.

  1. 1Reconstitute the antibiotic powder in the vial with the prescribed sterile diluent and gently agitate until fully dissolved.
  2. 2Inject the reconstituted medication into the secondary IV fluid bag and gently rotate the bag to mix the solution.
  3. 3Spike the secondary IV bag with the secondary tubing, prime the line to clear all air, and close the roller clamp.
  4. 4Scrub the primary IV tubing Y-site port located above the infusion pump with an antiseptic wipe.
  5. 5Attach the secondary tubing to the upper Y-site, lower the primary fluid bag using an extension hanger, and fully open the secondary roller clamp.

Cevap

The correct sequence for IV piggyback setup is to first reconstitute the medication, inject it into the secondary dilution bag, prime the secondary tubing, asepticize the proximal Y-site port, and finally connect the tubing while lowering the primary fluid bag.
Establishing a secondary IV piggyback infusion requires a precise chronological workflow to ensure pharmacological safety and mechanical function. The medication must first be reconstituted from its powder form and then injected into the secondary bag for proper dilution. Before connecting anything to the patient's existing line, the secondary tubing must be spiked and primed to eliminate air. Aseptic technique dictates scrubbing the proximal Y-site port (above the pump, to ensure the pump regulates the rate) before attachment. Finally, the mechanical principles of gravity-fed infusion require lowering the primary fluid bag so the higher secondary bag exerts greater hydrostatic pressure, ensuring the pump draws the medication first.

Adım Adım Çözüm

1
Reconstitute the antibiotic powder.
The solid medication is transformed into a concentrated liquid solution.
Lyophilized powders must be dissolved in a sterile diluent before they can be added to larger fluid volumes.
2
Inject the reconstituted drug into the secondary IV bag.
The medication reaches the appropriate therapeutic concentration for infusion.
Direct administration of concentrated reconstituted medication can cause severe phlebitis or speed shock; it requires proper dilution.
3
Prime the secondary IV tubing.
Air is completely removed from the secondary line.
Purging air from the tubing is an essential safety requirement to prevent a potentially fatal air embolism.
4
Scrub the primary tubing Y-site port above the pump.
The connection site is sterilized.
Accessing any IV port without rigorous disinfection introduces a high risk of bloodstream infections.
5
Attach the secondary line, lower the primary bag, and open the clamp.
The secondary infusion is ready to be delivered by the pump.
Because the pump draws fluid from the highest source, the primary bag must be positioned lower than the secondary bag for the piggyback medication to infuse first.

Anahtar Kavram

Safe intravenous piggyback (IVPB) administration requires sequential reconstitution, dilution, line priming, aseptic connection at a proximal port, and gravity-assisted flow prioritization.
Bu soruyu puanla

Konular

Pharmacological and Parenteral Therapies

Bu konudan daha fazla soru