Examkin

Soru

Zorluk: ZorTechnical Specifications, Quantities, and Measurements

Listen to the following excerpt from a technical training recording on assembling a high-torque conveyor drive:

"Before securing the drive motor, tighten the four primary anchor bolts to 85 newton-meters in a cross pattern. Next, calibrate the belt tension so that lateral deflection remains at exactly 6 millimeters under a 50-newton applied load, ensuring it never exceeds the 8-millimeter maximum limit. When configuring the variable frequency drive, maintain a frequency of 25 hertz for standard low-speed sorting and 40 hertz for high-speed transfer mode. Lastly, set the automatic lubrication system to dispense 120 milliliters per hour during the initial 48-hour break-in cycle, after which the delivery rate must be reduced to 80 milliliters per hour for routine operation."

According to the instructions, which of the following is the required lubrication delivery rate for routine operation after the initial break-in period?

  1. A
    120 milliliters per hour
  2. B
    85 milliliters per hour
  3. 80 milliliters per hourCevap
  4. D
    48 milliliters per hour

Cevap

The required lubrication delivery rate for routine operation is 80 milliliters per hour.
The speaker explicitly specifies that once the 48-hour break-in cycle concludes, the automatic lubrication system must be adjusted to dispense 80 milliliters per hour for regular, routine operation.

Adım Adım Çözüm

1
Identify the relevant technical system and measurement parameter requested in the prompt.
The target parameter is the rate of automatic lubrication dispensing for routine long-term operation.
The question specifically asks for the post-break-in operational rate rather than mechanical torque, belt deflection, frequency, or initial break-in settings.
2
Isolate the section of the audio excerpt detailing the lubrication protocol and its sequential stages.
The recording specifies two phases: 120 milliliters per hour during the first 48 hours (break-in), followed by a reduction to 80 milliliters per hour for routine operation.
Differentiating between the sequential conditions prevents selecting the preliminary calibration value.
3
Match the target condition ('routine operation after the initial break-in period') with the corresponding quantity.
80 milliliters per hour corresponds directly to routine operation.
This precisely satisfies the technical specification requested.

Anahtar Kavram

Extracting and distinguishing technical specifications, metric units, and multi-phase operating parameters from spoken instructions.
Tahmini Süre:1m 30s
Bu soruyu puanla

Konular

Technical Specifications, Quantities, and Measurements

Bu konudan daha fazla soru