Examkin

Soru

Zorluk: OrtaPower Grinders

An automotive technician needs to replace a worn grinding wheel on a handheld portable angle grinder and verify it is safe for operation. Place the following procedural steps in the correct chronological order from first to last.

  1. 1Disconnect the angle grinder from its electrical power supply or remove its battery pack.
  2. 2Depress the spindle lock button and use the manufacturer's pin spanner wrench to loosen and remove the outer clamping flange.
  3. 3Inspect the replacement abrasive disc for physical defects and verify that its maximum rated RPM is equal to or greater than the grinder's no-load speed.
  4. 4Position the new wheel onto the spindle against the inner flange and tighten the outer lock nut firmly with the spanner wrench.
  5. 5Reconnect the tool to power, point the guard and disc in a safe direction away from bystanders, and execute a 30-second unloaded test run.

Cevap

The correct sequence begins with isolating power, removing the old flange using the spindle lock and spanner, inspecting the replacement wheel's RPM rating and condition, securing the new wheel with the clamping flange, and concluding with an unloaded 30-second trial test run.
The correct procedural sequence follows fundamental shop safety and mechanical standards: first isolate electrical power to eliminate accidental startup hazards, remove the outer flange using the proper lock and pin spanner, inspect the replacement wheel's physical condition and RPM rating compatibility, securely clamp the wheel onto the spindle, and finally conduct an unloaded 30-second test run under guard protection before workpiece contact.

Adım Adım Çözüm

1
Isolate the tool from its power source by unplugging the power cord or ejecting the battery pack.
The tool cannot be accidentally energized while hands are near the arbor.
Prevents catastrophic laceration and entanglement injuries during disc changing.
2
Engage the spindle lock pin and use the designated pin spanner wrench to unscrew the outer retaining flange nut.
The clamping pressure is released, allowing removal of the old abrasive disc.
Using the correct wrench prevents damage to the spindle threads and arbor assembly.
3
Examine the replacement wheel for cracks and confirm that its marked maximum operating RPM meets or exceeds the grinder spindle RPM.
Verification of wheel integrity and operating speed safety.
Mounting an under-rated or cracked wheel can cause explosive wheel disintegration at operating speeds.
4
Mount the new disc onto the spindle over the inner flange, thread on the outer flange nut, and tighten it securely using the pin spanner.
The new abrasive wheel is centered and clamped securely on the drive spindle.
Proper clamping torque prevents slippage while ensuring the disc is not warped or overstressed.
5
Reconnect power and run the grinder freely at full speed under the safety guard for 30 seconds while facing away from the wheel plane.
Dynamic verification of wheel balance, concentricity, and mechanical soundness.
Any hidden manufacturing flaw or balance issue will manifest safely during an unloaded test run prior to actual grinding.

Anahtar Kavram

Portable Angle Grinder Wheel Replacement and Pre-Operation Safety Verification
Tahmini Süre:1m 0s
Bu soruyu puanla

Konular

Power Grinders

Bu konudan daha fazla soru