Examkin

Soru

Zorluk: Çok zorSpeed and Road Conditions

A commercial driver is operating a loaded tractor-trailer on a highway that has just become wet from heavy rain. The driver is approaching a downgrade curve that can be safely negotiated at 45 mph45\text{ mph} under completely dry conditions. The vehicle is currently operating with the engine retarder engaged. Based on commercial driving safety standards for speed management and road conditions, which sequence of actions is required to safely navigate this hazard?

  1. A
    Keep the engine retarder engaged on a low setting to assist with deceleration on the downgrade, and reduce the vehicle's speed to 30 mph30\text{ mph} before entering the curve.
  2. B
    Disable the engine retarder immediately, enter the curve at the dry-road speed of 45 mph45\text{ mph}, and progressively apply the service brakes while in the turn to reach a safe speed.
  3. Disable the engine retarder immediately, reduce the vehicle's speed to 30 mph30\text{ mph} before entering the curve, and avoid braking while actively turning.Cevap
  4. D
    Disable the engine retarder immediately, reduce speed to 30 mph30\text{ mph} before the curve, but base any emergency stopping expectations solely on the vehicle's mechanical braking distance.

Cevap

The driver must disable the engine retarder immediately, reduce the vehicle's speed to 30 mph30\text{ mph} before entering the curve, and avoid braking while actively turning.
According to commercial driving guidelines, wet roads require a speed reduction of about one-third. Therefore, a 45 mph45\text{ mph} dry speed must be reduced by 15 mph15\text{ mph} to 30 mph30\text{ mph}. This speed reduction must occur prior to entering the curve to prevent lateral skidding. Furthermore, engine retarders must be entirely disabled on wet surfaces because they isolate braking force to the drive wheels, which can easily induce a jackknife skid when traction is poor.

Adım Adım Çözüm

1
Determine the appropriate speed reduction ratio for a wet road surface.
CDL guidelines mandate reducing speed by approximately one-third on wet roads. One-third of 45 mph45\text{ mph} is 15 mph15\text{ mph}, resulting in a safe target speed of 30 mph30\text{ mph}.
Water acts as a lubricant on the road surface, significantly reducing tire traction and requiring lower speeds to maintain control.
2
Identify the correct timing for the required speed reduction when approaching a curve.
The speed must be reduced to the target 30 mph30\text{ mph} before the vehicle enters the curve.
Braking while steering inside a curve demands excessive traction; on a wet surface, this will likely exceed the tires' friction limits and cause a skid.
3
Determine the correct engine retarder configuration for compromised road conditions.
The engine retarder must be turned off immediately.
Engine retarders apply heavy braking force exclusively to the drive wheels. On slippery surfaces, this concentrated force can easily lock the wheels and induce a dangerous drive-wheel skid.
4
Evaluate assumptions regarding emergency stopping distances in these conditions.
Total stopping distance must always factor in perception distance, reaction distance, and braking distance.
Ignoring perception and reaction times leads to a dangerous underestimation of the physical space required to bring the vehicle to a complete halt.

Anahtar Kavram

Synthesizing speed adjustments for compromised surfaces, proper braking techniques for curves, and safe usage limits of engine retarders.
Bu soruyu puanla

Konular

Speed and Road Conditions

Bu konudan daha fazla soru