Examkin

Soru

Zorluk: ZorVideo, Display, and Projector Issues

A systems technician is troubleshooting a ceiling-mounted DLP projector in a corporate boardroom. During presentations, the projector functions normally for roughly 15 to 20 minutes, after which the lamp abruptly shuts off, the temperature LED flashes red, and the internal cooling fans spin at maximum speed for several minutes before the unit switches to standby mode. The projector bulb was replaced last week and has logged fewer than 30 total hours of use. Which of the following is the most likely cause of this symptom, and what is the BEST action to resolve it?

  1. Dust accumulation has blocked the projector air intake filters, triggering thermal overload protection; clean or replace the air filters and clear surrounding airflow obstructions.Cevap
  2. B
    The dedicated VRAM on the host workstation's graphics adapter is thermal throttling; roll back the display driver software on the connected computer to a previous stable release.
  3. C
    The high-voltage CCFL backlight inverter inside the projector assembly has degraded; disassemble the chassis to replace the display inverter board.
  4. D
    The video signal cable has exceeded maximum passive attenuation limits; swap the HDMI cable for a legacy single-link DVI-D cable connection.

Cevap

Dust accumulation has blocked the projector air intake filters, triggering thermal overload protection; clean or replace the air filters and clear surrounding airflow obstructions.
The correct answer identifies blocked air filters as the root cause. Projectors generate intense heat from high-wattage lamps or light engines. When intake filters gather dust, airflow is restricted, causing internal operating temperatures to climb. Once internal thermistors hit critical thresholds, thermal overload protection automatically extinguishes the lamp and runs the cooling fans at maximum speed to prevent catastrophic hardware damage.

Adım Adım Çözüm

1
Analyze the reported symptoms and hardware environment.
The projector functions normally for 15-20 minutes before experiencing a lamp shutdown accompanied by a red temperature warning LED and maximum fan speed.
Delayed failures occurring after a consistent period of time are classic indicators of heat buildup and thermal protection mechanisms.
2
Evaluate thermal and cooling system causes versus alternative hardware failures.
Recent bulb replacement eliminates lamp wear. The specific temperature LED indicator points directly to an internal thermal condition rather than a video source or signal transport issue.
Projectors contain thermal cut-off switches that shut down the lamp while running fans at full speed to cool the internal housing when intake airflow is restricted.
3
Select the appropriate remedial action based on CompTIA troubleshooting methodology.
Cleaning or replacing clogged air filters restores required cubic-feet-per-minute (CFM) airflow, resolving the overheating condition non-destructively.
Maintaining clean ventilation pathways is the standard preventive and corrective step for thermal shutdown symptoms in projection equipment.

Anahtar Kavram

Projector Thermal Management and Overheating Symptoms
Tahmini Süre:2m 0s
Bu soruyu puanla

Konular

Video, Display, and Projector Issues

Bu konudan daha fazla soru