Examkin

Soru

Zorluk: ZorLaptop Power Systems and Battery Management

A field technician is servicing a laptop that powers on and operates normally on battery power. However, when the original manufacturer barrel-connector AC adapter is plugged in, the battery status icon in the operating system displays "Plugged in, not charging," and processor performance is noticeably degraded. The technician reboots into the system BIOS/UEFI setup utility, where the AC Adapter Type is listed as "Unknown." Which of the following is the most likely cause of this issue?

  1. The signal pin inside the barrel connector or DC-in power jack is damaged, preventing communication between the adapter's identification chip and the motherboard.Cevap
  2. B
    The laptop battery requires a series of complete 0% deep discharge and 100% recharge cycles to recalibrate the fuel gauge microcontroller.
  3. C
    The power port lacks hardware support for the Thunderbolt protocol required to negotiate high-wattage power delivery profiles.
  4. D
    The dual-channel system memory configuration has defaulted to single-channel mode, restricting motherboard power distribution lines.

Cevap

The center signal pin within the AC adapter barrel connector or internal DC-in power jack is physically damaged, preventing the motherboard from reading the power adapter's wattage identification chip.
The correct answer correctly identifies that modern laptop barrel connectors utilize a center signal pin to communicate charger wattage specifications to the system's embedded controller. When this pin or the internal DC jack is damaged, the BIOS cannot identify the adapter, causing the system to refuse battery charging and throttle performance to protect system hardware from over-current draw.

Adım Adım Çözüm

1
Analyze the diagnostic symptoms presented in the scenario.
The laptop runs on battery power, but when plugged into AC power, the OS reports 'Plugged in, not charging', CPU performance throttles, and BIOS lists AC Adapter Type as 'Unknown'.
When a laptop firmware cannot verify the wattage rating of an attached charger, it enters a fail-safe mode: it avoids drawing unverified power to charge the battery and throttles CPU performance to stay within minimum safe current limits.
2
Evaluate how laptop AC adapters communicate identification to the system board.
Proprietary barrel connectors use a small central pin to transmit data from a 1-wire identification IC inside the charger brick to the system embedded controller (EC).
If this pin is bent, broken, or suffering from a cracked solder joint on the DC-in jack, the EC reads 'Unknown' power input.
3
Differentiate correct hardware diagnostics from common misdiagnoses.
Discharge calibration attempts, protocol mismatches (such as Thunderbolt vs USB-C), and RAM configurations do not cause the AC adapter ID to read as 'Unknown' in BIOS.
Physical pin failure on the barrel connector/jack is the direct root cause of unrecognized power adapter hardware signatures.

Anahtar Kavram

Laptop AC Adapter Identification and Fail-Safe Power Throttling Management
Bu soruyu puanla

Konular

Laptop Power Systems and Battery Management

Bu konudan daha fazla soru